fillalph

Again, sorry that my signature hasn't been updated, but I am running F11 already. I am wondering if perhaps I should change from ACHI --> IDE in the bios and reinstall Vista? I never had any problems in XP like this but then again, I was using IDE mode.

I guess I should have said that I have already reinstalled Vista after I did the switch from IDE to ACHI.

Hi Guys, Thanks for the responses. @brucevangeorge: It says ACPI x64-based PC @cluberti: when I say the CPU has shutdown I mean that the only thing "on" is the optical drive (I can open/close the tray) and the fans. @puntoMX: I haven't made a whole lot of changes to the BIOS. I did switch from IDE to SATA mode - AHCI enabled, no RAID and I manual set my memory timings (to spec though, no overclock). My install is also a slipstream SP1 image (from Microsoft, not nLited).

I installed Windows Vista Business x64 and am having some problems. When I shutdown the computer, CPU stops but the fans and dvd drive still have power (I don't know about the harddrive). I have to hold the power button for 4 seconds to turn it off completely. When turning on the computer later, I never get a message saying that windows didn't shutdown properly - this leads me to believe that the shutdown went alright, but for some reason the peripherals don't get command to shutdown. I have already gone in the power settings and changed it so that the power button and start menu power button "shut down" and in the sleep settings both sleep and hibernate are set to "never". What I am running: GA-P35-DS3R rev. 1 (bios F12) Intel E6550 h 2.33Ghz XFX 7600GS (driver - 175.16_geforce_winvista_64bit_english_whql) OCZ Platinum XTC REV.2 PC2-6400 2GB Corsair HX520W CMPSU-520HX Western Digital SE16 320GB SATA2 Updated Chipset drivers to v9.0.0.1008 Realtek Audio and Lan drivers are up to date too. I did the performance shutdown and here is the link to the file: shutdown_BASE+CSWITCH+DRIVERS+POWER_1.etl Any ideas? -fillalph

Newzbin? I used to use it about 2 years ago and today went to check it out again, but it is invite only. I was hoping I could get an invite from someone here. If you have one available, my email is my msfn username @ gmail.com Thanks fillalph

Hello, Here is our current setup: Linksys Modem --> Linksys WRT54GL (Tomato firmware) --> D-LINK DES-1024D where all our wired computers in the company connect to (about 18 or so). The WRT54GL also has wireless enabled and we are using WAP AES for security. At the moment we are sharing folders within the company through Microsoft sharing (simple file sharing and the like). I am going to be install a Linux fileserver in the next week or so though. (Please don't laugh ). The wireless wasn't encrypted before and the transport trucks used to go on it while waiting for their trailers to be loaded. Since we added security, they can't and have asked if we could open it up again. If don't mind sharing the internet with them, but as a result, they do get access to the network. I was thinking perhaps I could leave the encryption on (keeps my bosses wireless encrypted), but give out the password to the truckers and in the Tomato settings, turn AP Isolation on. The other idea would be to buy another Linksys WRT54GL router and connect it to the D-LINK DES-1024D switch and turn off the encryption, turn AP isolation on and disable the WAN (in the basic network settings)? Any opinions. Thanks