Hi Tommyp

I experienced the following problems. Hope you can help to take a look.

I noticed during setup stage, I was not prompt during the "regional & language setting" to select my Region Zone.
It was skipped. Setup proceed to Installating Network.

Then at T29 stage (Copying files...), it was skipped.
Same for T25 (Completing Installation...)
Setup proceed normally at T22 (Installating Start Menu Items...) till the end of setup.

After 1st bootup, I got error "framdyn.dll was not found".

I done some simple testing by retaining IE6 & WMP9. Still face teh same problem. Skipping setup stages as mention above.
Despite retaining IE6 & WMP9 for T/s purpose, I did not have IE & WMP after installation.

Also application addon (HFAAO) with sysoc.inf type were not slipstreamed. Svcpack.inf type works okay
HFEXPERT\PROGRAMFILES were not slipstream at all.

Also notice MSpaint was not installed. There may be some other files not installed but I did not check everything as I think skipping T29 & T25 probably cause these files not installed correctly.

Attached is my Log

I also face the same problem with earlier version of HFslip (1.7.7 & 1.7.6rc3)

Can you remove all addons, all HFEXPERT stuff and anything from the REPLACE folder and try again? I can only see three possibilities:

- corrupt source
- broken or incomplete addon(s)
- bad files in the REPLACE folder

Yes! Removed all REPLACE, HFEXPERT stuff & all addon while keeping only HF stuff, all setup routine now went normally.

Now to slowly identify which is the culprit...

Thanks again