first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it
F3 T>/2
F3 2> Z
spin down complete

F3 2 > U

Spin up complte

F3 2 > /1

F3 1 > N1

and it gave error and hanged there

when turning off and back on
the drive
doesnt properly spin up
it tries to initialize but doesnt and stops


any suggestion
it all happend after N1 command failure

plz post some suggestion

Did you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board?

yes i did complete tighten the screws ....but still it tries to spin and stop spins and stop ....doesnt spin up fully upto drive initialisation

Did you use a card between the contacts and PCB?

Check this:
http://www.msfn.org/board/solution-seagate...-page-2021.html

jaclaz