This fix will add support for USB floppy disks in the text mode portion of Windows Setup, and allow you to load F6 drivers. This fix should work on Windows 2000 and up. I have only tested it with a Sony USB floppy drive on Windows XP and Windows Server 2003 x64 EDIT: Thanks go out to everyone who has added more drives to this fix. --- Windows Setup F6 USB Floppy Drive Fix Create your Storage device driver disk and open textsetup.oem Add the following lines to the bottom of [HardwareIds.scsi.(device name)] If this section does not exist you must create it! If your USB floppy drive still does not work, look for the hardware ID in the floppy drive driver's .inf file, and make sure any legacy floppy drives are disabled in the bios. id = "USB\VID_03F0&PID_2001", "usbstor" #--HP id = "USB\VID_054C&PID_002C", "usbstor" #--Sony id = "USB\VID_057B&PID_0001", "usbstor" #--Y-E Data id = "USB\VID_0409&PID_0040", "usbstor" #--NEC id = "USB\VID_0424&PID_0FDC", "usbstor" #--SMSC id = "USB\VID_08BD&PID_1100", "usbstor" #--Iomega id = "USB\VID_055D&PID_2020", "usbstor" #--Samsung Here is an example file #////////////////////////////////////////////////////////////////// [Disks] d1 = "Intel Embedded Server RAID Technology",\MegaSR,\ [Defaults] scsi = MegaSR [scsi] MegaSR ="Intel Embedded Server RAID Technology (Windows XP/2003 64-bit)", MegaSR [Files.scsi.MegaSR] driver = d1, MegaSR.sys, MegaSR inf = d1, MegaSR.inf inf = d1, NODEV.inf catalog = d1, MegaSR.cat [HardwareIds.scsi.MegaSR] id="PCI\VEN_8086&DEV_2682&SUBSYS_10901734", "MegaSR" id="PCI\VEN_8086&DEV_2683&SUBSYS_10901734", "MegaSR" id="PCI\VEN_8086&DEV_2682&SUBSYS_81FF1043", "MegaSR" #--The following lines give additional USB floppy support id = "USB\VID_03F0&PID_2001", "usbstor" #--HP id = "USB\VID_054C&PID_002C", "usbstor" #--Sony id = "USB\VID_057B&PID_0001", "usbstor" #--Y-E Data id = "USB\VID_0409&PID_0040", "usbstor" #--NEC id = "USB\VID_0424&PID_0FDC", "usbstor" #--SMSC id = "USB\VID_08BD&PID_1100", "usbstor" #--Iomega id = "USB\VID_055D&PID_2020", "usbstor" #--Samsung [Config.MegaSR] value = "Parameters\PnpInterface", 5, REG_DWORD, 1 #//////////////////////////////////////////////////////////////////