Jump to content

dilosolid

Member
  • Posts

    12
  • Joined

  • Last visited

  • Donations

    0.00 USD 
  • Country

    Dominican Republic

About dilosolid

dilosolid's Achievements

0

Reputation

  1. Gradius2 did u apply the fixed SD1A firmware to the ST3750330AS ?
  2. did u see this page? http://www.msfn.org/board/index.php?showto...20&start=20
  3. i notice alot of ppl are having trouble updating the drives in the seagate forum
  4. ahh ok well the HD jumpers pins output 3v so i think u need the 3.3v adapter
  5. buy the 5v so u can use the Power supply RED cable to get the 5v u need another thing is that my cable work with 3.3v and 5v dunno why they sell 2 diferent cables
  6. i think those will work but this is a lot cheaper http://cgi.ebay.co.uk/MAX232-RS232-to-TTL-...%3A1|240%3A1318
  7. thx Gradius2 and fatlip for the help the drive is fixed now another thing why the seagate serial checker say my drive is no affected went it is?
  8. maybe i got the error because i was trying to do this command m0,2,2,0,0,0,0,22 without the hard drive case on
  9. ok Gradius2 i couldn't get output from the console but then i press CTRL-Z and got output F3 T> now i getting this error went i try to put this command F3 T>m0,2,2,0,0,0,0,22 LED:000000CC FAddr:0025BF67
  10. Are you sure didn't you mixed TX with RX ? Are you sure RS232 is configured to 38400 8 N 1 ? Keep in mind you need a RS232 to TTL conversor/adapter, otherwise it will never works! If all above is correct, did you pressed CTRL+Z in order to get into CMD mode ? Gradius i have try TX and RX both way the cable i'm using is a homemade cable with the MAX232 IC and 4 capacitors i'm 100% sure the cable is working do i get output before i press CTRL+Z?
  11. i have a 7200.11 with the LBA0 problem I'm trying to fix the drive but i cannot get any output from the console, i know the cable is working because i tested it with another device and i get output anyone else has this problem too?
×
×
  • Create New...