eliz

Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About eliz

  1. skip N1, restore drive to defaults, then send m0,2,2,0,0,0,0,22 Hello avico, you are amazing, i restored my hard without a bit of data loss! I don't know how to thank you, i wish you success in life Visit this site for some amazing photos of nature: http://www.glanzlichter.com/template/index...57/13/index.htm I also thank you Gladius, thank you very much
  2. thank you but do you mean removing the pcb totally or just the part related to the spin motor? (i tried once by just disconneting the spin motor part of the pcb and the terminal seemed not working) I dont know who was stupid enough that told to insulating pins from motor (in original source user should insulate connector which goes to head assembly) remove whole pcb and check that you can connect to terminal, if you can i will guide you what to do. aviko, it worked, i am now in terminal, what should i do? aviko, should i execute this command or not: F3 1>N1 (enter) and also shouldn't i power off and then ON before this command: F3 T>m0,2,2,,,,,22 (enter) Thanks
  3. thank you but do you mean removing the pcb totally or just the part related to the spin motor? (i tried once by just disconneting the spin motor part of the pcb and the terminal seemed not working) I dont know who was stupid enough that told to insulating pins from motor (in original source user should insulate connector which goes to head assembly) remove whole pcb and check that you can connect to terminal, if you can i will guide you what to do. aviko, it worked, i am now in terminal, what should i do?
  4. remove pcb from hdd, plug terminal connectors, connect power and try to open terminal. when you got prompt repeat all but skip i4,1,22 thank you but do you mean removing the pcb totally or just the part related to the spin motor? (i tried once by just disconneting the spin motor part of the pcb and the terminal seemed not working)
  5. Hi, i had the BUSY problem, everything went normal until i reconnect hard power after disconnecting it after this command: F3 T>i4,1,22 (enter) and by connecting the prower my computer hanged (maybe power shortage?) Now my hard is detected but BIOS says it has error! And the firmware updater dose not update it too. What could i do now? I tried to go to the terminal again, but it seems not working. Any solution? Thanks anyway