maxjix

Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About maxjix

  1. Congratulations! I love everyone I success. and I take the my family pic & working folder so much thanks !!!! my experience: typing slow each command line !! fast typing make 0000ce error and I fix some confusing command. ------------------------------------------------------------------------------------------- On terminal you'll see nothing, just press CTRL+Z. And you'll get F3 T> prompt. With PCB disconnected from HDA with a paper card (or similar), you'll see: On terminal press CTRL+Z: F3 T> (Wait 5sec) F3 T>/2 (Wait 5sec) F3 2>Z (not small z) Spin Down Complete Elapsed Time 0.147 msecs F3 2> (Wait 5sec) remove the paper card, this will connect the PCB to HDA (spin motor), but since is in Spin Down state (from cmd), you'll feel nothing. Now screw just enough to make a good contact between PCB and HDA (be real careful here, don't drop the screw, just be calm, relax!). Then press CTRL+Z again: F3 T> (Wait 5sec) F3 T>/2 (Wait 5sec) F3 2>U Spin Up Complete Elapsed Time 7.457 secs (if you get this msg you did everything fine until here) F3 2>/1 (Wait 5sec) F3 1>N1 (Wait 5sec) F3 1>/T (Wait 5sec) F3 T> <<< At this step you'll need to POWER OFF your HD for 10sec, and then POWER ON again. By power off, remove the SATA power (not PCB!). When done, press CTRL+Z. F3 T> F3 T>i4,1,22 F3 T> F3 T>m0,2,2,,,,,22 <<< This command takes a little over a minute to complete! Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 14, Max Certify Rewrite Retries = 00C8 User Partition Format 5% complete, Zone 00, Pass 00, LBA 00004339, ErrCode 00000080, Elapsed Time 0 mins 05 secs User Partition Format Successful - Elapsed Time 0 mins 05 secs F3 T> ------------------------------------------
  2. HELP ~~~ I disconnect PCB board from HDA and F3 T>/2 (enter) F3 2>z (enter) LED:000000CC FAddr:0025BF67 LED:000000CC FAddr:0025BF67 LED:000000CC FAddr:0025BF67 LED:000000CC FAddr:0025BF67 and not response any idea ? help ~~~