a8nsli

Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About a8nsli

Profile Information

  • OS
    XP Pro x86
  1. hello my dear my name is precious pleas reply view my email

    preciousjas73@yahoo.com

  2. VideoRipper thank you very much, the problem was simply the "/" before the 2. Sometimes they are simple things you can not see. I just repaired 3 hard drives. I'm happy;)
  3. I believe my steps are correct, please correct me if I'm wrong. These are my steps: 1 - Remove or separator in the top 3 contacts the controller. 2 - connect rx, tx and mass 3 - connect SATA power 4 - open hyperterminal 5 - Configure Connection COM10, 38400, 8, nothing, 1, none 6 - Ctrl + z 7-T responds F3> 8-type 2 9 And from that step always responds LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 Greetings and thanks for the help.
  4. tried and nothing. continues the same. I turn the HD on, wait to the engine to start spinning, unscrew the screw and then lift up and put a separator. It stops, I try to connect with hyperterminal. Same failure.
  5. the bios does not recognize me the disks, I'll try anyway. Thanks
  6. Hello everyone, first of all apologize for my English as it is translated. I have two hard disks affected by the problem of one is a seagate firmware and the other maxtor. The models are: Maxtor DiamonMax22 STM3500320AS FIRMWARE MX15 Seagate Barracuda ST500320AS FIRMWARE SD15 I've been reading this forum and I built a cable from data cable CA-42 USB as I reached for another COM port adapter bought on Ebay that also is this DIGITAL CONVERTER KIT CMOS / TTL TO RS232, 3V, Low Power . What you can see here http://cgi.ebay.es/ws/eBayISAPI.dll?ViewItem&item=200360298309&ru=http%3A%2F%2Fshop.ebay.es%3A80%2F%3F_from%3DR40%26fts%3D2%26_trksid%3Dp3686.m38.l1313%26_nkw%3D200360298309%26_sacat%3DSee-All-Categories%26_fvi%3D1&_rdc=1 I use hyperterminal xp professional and properly configured. Remove the pcb disk and connect the Tx and Rx. Then I feed the sata connector on the PC. The question is that with both wires get the same result in hyperterminal marking the beginning and is Ctrl + F3 T z> then frame 2 and the result is this F3 T> 2 LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 LED: 000000CC FAddr: 0025BF67 ... Cyclically So I find no way of marking the Z because it lets me get to that point. I have read every post I could but it's the 2 weeks I am with this and now I can only ask you. Does anyone of you have or have turned this problem?. Thanks for your help. Saludos