Jump to content

fake 16GB USB Flash Drive

namo

By namo
in Hard Drive and Removable Media

 Share

Recommended Posts

namo

namo

Posted
Posted (edited)

Hello,

I have 16GB Flash Drive and it seems fake. I think its true size 1.95GB(its real commercial capacty might be 2GB) ( I have fill it with video files they working before 1.95GB; and file after that are corrupted ).

I want to show the true Capacity. I have tried iformat 4.18, iformat2 1.19 and 1.32, pdx8_2k_v327 and PDx16. But non of these show the flash drive.

I bought fake 16GB drive before and it was fake 2GB, PDx16 and iformat2 1.32 were detecting it. I used iformt2 1.32.

I want to show the true Capacity To safe uncorrupted files.

Note: from the device manager, the drive is Hisun Flash Drive USB device

additional information:

Name: Flash Disk		(USB1.1)

Logic Driver: K:\ 

VID&PID: Vid_2008&Pid_2018
Speed: full speed

VendorID: Hisun
ProductID: Flash Disk
Product Revision: 2.10

Vendor Description: Hisun   
Product Description: Flash Disk	  
Serial Number: O20070925A000392

the Dis Mangament shows:

16GB FAT32
healthy

the USB port information
Device Descriptor:
bcdUSB:			 0x0110
bDeviceClass:		 0x00
bDeviceSubClass:	  0x00
bDeviceProtocol:	  0x00
bMaxPacketSize0:	  0x40 (64)
idVendor:		   0x2008
idProduct:		  0x2018
bcdDevice:		  0x0000
iManufacturer:		0x01
iProduct:			 0x02
iSerialNumber:		0x03
bNumConfigurations:   0x01

ConnectionStatus: DeviceConnected
Current Config Value: 0x01
Device Bus Speed:	 Full
Device Address:	   0x05
Open Pipes:			  2

Endpoint Descriptor:
bEndpointAddress:	 0x81
Transfer Type:		Bulk
wMaxPacketSize:	 0x0040 (64)
bInterval:			0x00

Endpoint Descriptor:
bEndpointAddress:	 0x00
Transfer Type:	 Control
wMaxPacketSize:	 0x0507 (1287)
wInterval:		  0x0201
bSyncAddress:		 0x40

Noe: I have tested the file using the explainarion given in the attached file.

Test_Fake_flash_memory.txt

Edited by namo
Link to comment
Share on other sites

namo

namo

Posted
  • Author
Posted (edited)
How does it show in Disk Management ?

I have added several small wave files in the flash drive until 1.95GB and after that the file started to become corupted so I know now that the true size is 1.95GB.

the Dis Mangament shows:

16GB FAT32

healthy

But it surely not healthy.

Edited by namo
Link to comment
Share on other sites
jaclaz

jaclaz

Posted
Posted (edited)

To try and identify the stick and (hopefully) the controller used:

Check the Vid and Pid of the stick:

http://www.911cd.net/forums//index.php?showtopic=15776

Check the list:

http://www.boot-land.net/forums/index.php?showtopic=1659

Try making an image of the stick using either:

Roadkil's Disk Image:

http://www.roadkil.net/program.php?ProgramID=12

or

dsfo from the DSFOK toolkit:

http://members.ozemail.com.au/~nulifetv/freezip/freeware/

http://members.ozemail.com.au/~nulifetv/fr...eware/dsfok.zip

Size of resulting image should be the correct size.

Edit:

HISUN should be this one:

http://www.hisuntec.cn/EN/index.html

(nothing really useful there) :(

jaclaz

Edited by jaclaz
Link to comment
Share on other sites
namo

namo

Posted
  • Author
Posted (edited)
Reformatt it as ntfs.

How I can bot reformat it as NTFS; the normal way doesn't work only FAT32 is given as a choice.

This link details how to check if the flash drive is fake.

And this link tells you what you can do.

What is the manufacturer of the flash drive in question?

I know that the flash drive is fake. It is approximately 1.95GB but I want to show its true capacity

To try and identify the stick and (hopefully) the controller used:

Check the Vid and Pid of the stick:

http://www.911cd.net/forums//index.php?showtopic=15776

Check the list:

http://www.boot-land.net/forums/index.php?showtopic=1659

Try making an image of the stick using either:

Roadkil's Disk Image:

http://www.roadkil.net/program.php?ProgramID=12

or

dsfo from the DSFOK toolkit:

http://members.ozemail.com.au/~nulifetv/freezip/freeware/

http://members.ozemail.com.au/~nulifetv/fr...eware/dsfok.zip

Size of resulting image should be the correct size.

Edit:

HISUN should be this one:

http://www.hisuntec.cn/EN/index.html

(nothing really useful there) :(

jaclaz

I don't want to test the flash drive but show its true capacity. I know that I can store up to 1.95GB.

Edited by namo
Link to comment
Share on other sites
Kelsenellenelvian

Kelsenellenelvian

Posted
Posted
I know that the flash drive is fake. It is approximately 1.95GB but I want to show its true capacity

HUH? If it is only 1.95 gigs then it is a 2 gig USB drive. You got suckered. You need to follow the links in the previous post and get your money back.

My memorex 2 gig USB drive shows as 1.91 gigs.

Link to comment
Share on other sites
bj-kaiser

bj-kaiser

Posted
Posted

The problem is even worse, my preferred magazine already had some articles about this problem.

Basically, the controllers of small sticks will be manipulated to report more capacity than there is hardware-wise. Everything that goes over the limit of the built-in flash, gets reported as good write by the controller, but when you try to read the data there all you get are zeros.

Ironically, their own PR department got betrayed, they had an offer with an USB flash disk as welcome gift. And said UFDs where manipulated in the same way.

Link to comment
Share on other sites
jaclaz

jaclaz

Posted
Posted
I don't want to test the flash drive but show its true capacity. I know that I can store up to 1.95GB.

Yep, we got that. ;)

1.95 Gb is NOT however an exact capacity, the actual "RAW" capacity of a stick depends on the kind of Flash IC are inside it, theoretically capacity goes like this:

128 Mb 131.072.000 bytes

256 Mb 262.144.000 bytes

512 Mb 524.288.000 bytes

1 Gb 1.048.576.000 bytes

2 Gb 2.097.152.000 bytes

some controllers leave this entire capacity "available", some use part of this capacity for internal use, knowing the exact (in bytes) amount of available space may help in identifying the controller.

The amount you are getting is the capacity after formatting (i.e. excluding the amount of space used by filesystem structures, which can vary depending on filesystem used and, in the case of FAT16/FAT32, on the size of clusters the format uses).

Point is, the ONLY way to do what you want is getting to know which EXACT make/model of USB controller is inside the stick AND with this information search for and hopefully find the right "Manufacturer Utility" or "Mass Production Tool" capable to reset the capacity data to the correct values.

This site:

http://www.everythingusb.com/forums/forumd...php?forumid=109

has lots of info about "fake" drives, and some possible ways to tru and fix them (see this just as an example):

http://www.everythingusb.com/forums/showth...mp;postid=25758

jaclaz

Link to comment
Share on other sites
namo

namo

Posted
  • Author
Posted (edited)
I know that the flash drive is fake. It is approximately 1.95GB but I want to show its true capacity

HUH? If it is only 1.95 gigs then it is a 2 gig USB drive. You got suckered. You need to follow the links in the previous post and get your money back.

My memorex 2 gig USB drive shows as 1.91 gigs.

I want solution to show the true capacity. I am not talking about getting my money back.

I don't want to test the flash drive but show its true capacity. I know that I can store up to 1.95GB.

Yep, we got that. ;)

1.95 Gb is NOT however an exact capacity, the actual "RAW" capacity of a stick depends on the kind of Flash IC are inside it, theoretically capacity goes like this:

128 Mb 131.072.000 bytes

256 Mb 262.144.000 bytes

512 Mb 524.288.000 bytes

1 Gb 1.048.576.000 bytes

2 Gb 2.097.152.000 bytes

some controllers leave this entire capacity "available", some use part of this capacity for internal use, knowing the exact (in bytes) amount of available space may help in identifying the controller.

jaclaz

the used space after formatting the Flash Drive is 16KB. I have check the acual size by adding several wav aduio files of size 860 KB using a code in bat file, the file were working until 1.95GB after that if I add one file it will work have the audio clip and the next one I add doesn't work. so the aproximate maximum size of files that I can but in the flash drive is 1.95 GB (2,103,115,776 bytes). THis is aproximation because if I add file less than 500KB might work but bigger than that will not work.

Edited by namo
Link to comment
Share on other sites
namo

namo

Posted
  • Author
Posted (edited)

I tried to format the Disk as NTFS but the format failed.

If it is not possible to show the true Capacity, Is there easy way to partition the Flash drive so I can put 1.95GB in First one and the rest in the second one.; and Can this solve the problem? I mean is the first portion of storing will go to the first disk.

Edited by namo
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...