Jump to content

Can't get media extender to work


Recommended Posts

My router recognizes my extender and vice versa but I can't get any further than that

I either get error message 0000002 or 00000204

Microsoft reports reason for error ooooo204 to be too many psotings in the security section of event viewer

I have only one post there

I have deleted messages in other sections of event viewer to no avail

I have checked firewall in windows and trend micro

I have made sure fast switching is enabled

I have reset reformatted and went up and down the stairs countless times

Suggestions please

Link to comment
Share on other sites


:thumbup

Thanks for all the help or not ... even one suggestion.

I found the solution on another site after weeks of trying every thing that was suggested. This applies to any virus software program. Even though I set the firewall setitngs to allow for the neccesary ports for the media extender it wasn't enough...

"I figured out what was causing my 00000204. It was McAfee, but not the firewall like one would suspect but Spamkiller. Once I uninstalled that, everything was fine. If you have McAfee or any other multi-module security package, uninstall it completely and then see if your extender works. Don't just disable it. That won't help. Also a good idea to disconnect from the net while you're trying this, because you'll be without protection while you're doing this. Then reinstall the program one module at a time, and check your connection each time. You shouldn't have to reinstall the MCX software, just hit okay after each module install, and see if the error comes up.

To reset the MCX, turn it off, hold the standby button (the one farthest to the right) and turn on the MCX. After 5 seconds release the button and then press it again for 5 seconds. When you release it, the center button should flash blue then turn back to green, and the MCX should be reset.

Hope this helps. I spent hours trying to figure it out, and Linksys support was absolutely no help at all. Their typical response is that the hardware is defective and should be sent to them for repair. I know winos that have more sense than they do...

James

01-05-2007 10:36 PM "

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...