[TerryFox]

Hi ... I have a XP sp3 disc which I would like to install or embedded a driver . Its for the SATA Controller driver . I have the file which is in a zip format and when I unzip it become a setup.exe file . How do you install this or embed it unto my xp sp3 disk ? Thanks

[johnhc]

TerryFox, unzip it again. You must get down to the folder that contains the .inf and txtsetup.oem files. I use 7-Zip for this. Enjoy, John.

[iamtheky]

run the command: setup.exe /?

figure out what the syntax is to admin install (or see if uniextract will unpack it )

then just pull the driver.

[TerryFox]

Thanks for responding, very much appreciated . I have another question . Can I just use this instead unto a floppy

http://downloadcenter.intel.com/filter_res...mp;submit=Go%21

My system is 32 bit and I am thinking I can just use 32-bit Floppy Configuration Utility from the link above . Install it unto a floppy and use an external flop drive .
I believe if it does load i have to select this >>> ICH8 HBM?AHCI SATA DRIVER Intrl ® 82801HEM?HBM SATA AHCI Controller . Am I on the right page ? Or am I way off base ?

Thanks

This post has been edited by TerryFox: 10 April 2009 - 11:09 AM

[johnhc]

TerryFox, you don't need any floppy utility because you are not making a floppy. Just DL the correct drivers for what you have and what your want to run. I don't have a clue what you should select. This is up to you to decide what you want to run. Enjoy, John.

[TerryFox]

Everything is good , I use nlite and embedded into my xp sp3 disk . I have it now install without any problems .

Thanks

[johnhc]

TerryFox, great! Glad to help. Have fun, John.