Jump to content

No first part, goes straight to second.


Recommended Posts

C:\Users\Matt\Desktop\WinSetupUSB\files\grub4dos>grubinst -v (hd1,0)

Start sector: 0x3F

Image type: NTFS

Install mode

grubinst: Write error

EDIT: Having had a look around the forums here I found this thread:

http://www.msfn.org/board/index.php?showtopic=133164

But I still have problems....I put them in that thread.

Edited by wivelden
Link to comment
Share on other sites


1. When using command prompt and every other tool mentioned below open it with administrator rights. Do you know how?

2. Null the first sectors on the USB:

http://www.msfn.org/board/index.php?showto...st&p=852517

3. Unplug and replug your USB stick after every write operation, using safely remove hardware icon

4. Format USB stick manually in NTFS using HPUSBFW.EXE in \WinSetupFromUSB\files\tools\. Keep in mind about admin rights.

5. Replug USB stick.

6. Close any windows explorer instances opened and any other program which may be accessing the USB stick. Disable antivirus program if you have such.

7. In CMD go to \WinSetupFromUSB\files\grub4dos\

8. Type

fsutil volume dismount H:

replacing H: with the drive letter of the USB stick

9. Immediately after that issue

grubinst -v (hd1,0)

assuming you have only 1 internal hard disk and no other USB disks plugged in.

10. If you see "write error" run fsutil again and grubinst right after it.

11. If still no luck- run fsutil again, but after it put grub4dos MBR-

grubinst -v (hd1)

12. If you succeed run WinSetupFromUSB (the test version above) and check only these 2 options:

-syslinux boot sector (ignore the warning about syslinux and NTFS)

-test in QEMU

13. Do you see grub4dos command prompt in QEMU?

14 If yes- close QEMU and put XP setup files or whatever you wanted to put on the USB stick. You should be good to go.

Link to comment
Share on other sites

Greetings again. I tried installing to another machine; a HP Mini Note 2133 (2GB-version). It went slowly (FAT32) but surely (~100min) and Windows got installed just fine without errors. However, I cannot boot the installation without booting it through the stick. I've tried recovery console from the stick, logging onto the installed windows, then using fixmbr and fixboot, but to no avail. I have three partitions on the disk, one blank, one with xp and one backup-partition preinstalled from HP. In windows, the windows-partition is marked as "boot" and "system." Any ideas? And yes, I've changed the boot-sequence in bios back to internal hard drive.

Edited by $hitblast
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...