Frontpage
Forums
Tutorials
Members
Calendar
Subscription
Donate
Links
Contact 
Help
Recently got a Transcend USB 3 controller card.
Installed in the motherboard fine, attached the Molex Power Lead.
Every time I boot my computer the controller fails with 'Power Surge on Hub Port'
Driver version is 2.1.29.0
Firmware of the controller is 4015.
Installing on an ASUS P5Q-E under Windows 7 x64
Any ideas???
Page 1 of 1
USB 3 Power Surge
Rate Topic:
Back to top
#2
- Gold Member
-
- Group: Members
- Posts: 1,111
- Joined: 17-June 05
Posted 28 December 2011 - 06:40 AM
Ok, fixed it!
It could have been one of the two:
I reseated the card, and also gave it power directly from the PSU via a new cable - before it was connected to a molex that was also powering other devices.
I'm going to say it was the power cable, giving it a direct feed with no other devices running off it.
It could have been one of the two:
I reseated the card, and also gave it power directly from the PSU via a new cable - before it was connected to a molex that was also powering other devices.
I'm going to say it was the power cable, giving it a direct feed with no other devices running off it.
Share this topic:
Page 1 of 1