[easyindian]

Hello there

I downloaded and extracted Nero 7.0.8.2. I try to make an administrative installation folder with 'msiexec /a
nero.msi', it starts the installation and then keep on asking different CAB files wich are not present in the cab subfolder. But i can install the full components from the same extracted files and the installation completed successfully. Please help if anyone knows the solution

Thanks

[boooggy]

after the extraction run the setup normally. then u will see that that .cabs which are missing get created. so after this u can make the admin install.....

[IceBlackIce]

hm i had the same exact problem...will try your solution

[easyindian]

Thanks Man

I will try this solution

[IceBlackIce]

i did try and it worked. Thanks so much

[easyindian]

Admin install worked. but when i try to start the installation with nero.msi, it gives an error saying 'installation must be started with setup.exe. i am facing the same problem with roxio easy media creator 8. could someone help?

thanks

[Dynaletik]

If you look here, you will see, that you have to create an mst file after doing the admin install. It isn't possible to install Nero without it, I think. Or you use the setupx.exe without admin install.

[easyindian]

Dynaletik, on Apr 12 2006, 01:36 AM, said:

If you look here, you will see, that you have to create an mst file after doing the admin install. It isn't possible to install Nero without it, I think. Or you use the setupx.exe without admin install.

Even with MST, problem exists. i have verified. again, admin install does not create a setupx.exe

[RogueSpear]

You can always modify the .msi file to eliminate that requirement which is what I do, but I remember seeing that there's a command line switch for getting around it. Might have been in the huge Nero thread in this forum.

[easyindian]

i get an error 'unable to access shell manager' after i direct edit nero.msi and run setup