[devil270975]

aittersu, on May 20 2008, 07:28 AM, said:

I integrated SP3 to my XP i386 source, and now also added WMP11 using the WMP 11 integrator, but I receive two errors:

Setup cannot copy the file wmdrmsdk.dll
And after that another error: mfplat.dll

Is this related to SP3?

Does someone have a solution for this?

I use winnt.exe to start the setup from a DOS boot environment.

i get this error also, i install from another partition with bartpe and calling winnt32.exe, should we integrate wmp11 before sp3???

[mrquincy]

I call upon this thread to rise from the dead!!!

I'm having issues with my WMP11 integrator that has not been addressed anywhere else in the forum that I've seen:

I first had the issue where I get the wdrm...dll error...fixed it...then I had the mfplat not found error. I followed these steps to resolve:

Quote

1) Cab the 2 files wmdrmsdk.dll, mfplat.dll with makecab and throw them in the i386 folder


2) In DOSNET.INF in the [Files] section add the 2 lines...

QUOTE
[Files]
d1,wmdrmsdk.dll
d1,mfplat.dll


3) In TXTSETUP.SIF in the [SourceDisksFiles] section add the 2 lines...

QUOTE
[SourceDisksFiles]
wmdrmsdk.dll = 100,,,,,,,2,0,0
mfplat.dll = 100,,,,,,,2,0,0

Now I'm getting this error:
unregmp2.exe - entry point not found
The procedure entry point MFPlatformStartup could not be located in the dynamic link library MFPlat.DLL

Noteworthy: I downloaded mfplat.dll from dll-files.com

This post has been edited by mrquincy: 01 May 2009 - 03:27 PM

[Lost In Canada]

Hi,

I'd also like to see this thread rise from the dead please!

I prefere to do my integration/patches manually and not rely on something like nLite.

Earlier in this thread a lot was mentioned about integrating the 5 or 6 exe's found within the WMP11 Package. I read about re-compression problems that seem to be solved with a newer version of the WMP integrator.

Could I bother you for the switches used on the files used and the order?

Also, I'm not sure about going back and changing any folders after running an integration?
Sounds like your talking about folders for a network install location?

I just want to integrate into my source and burn to disk.
My project is simple, integrate everything I can and then make 1 or 2 packages to be run after the install is complete.

Any help?

Jason