MSFN Forum: [general] ac adapter noise - MSFN Forum

Jump to content



Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

[general] ac adapter noise Rate Topic: -----

#1 User is offline   pcandpc 

  • Member
  • PipPip
  • Group: Members
  • Posts: 138
  • Joined: 03-July 05

Posted 23 May 2007 - 11:50 AM

Hi,

I am hearing some electrostatic noise from
the ibm laptop ac adapter.

It is the noise you would hear from some
poor radio communication or such when
you hold the adapter close to your hear.

By the way, the adapter is hot, and I suppose
this is normal when it's working, right?

And, is the noise normal too?

Thanks.


#2 User is offline   CptMurphy 

  • Just another techie
  • PipPipPipPip
  • Group: Members
  • Posts: 534
  • Joined: 15-October 05

Posted 23 May 2007 - 01:18 PM

Well I don't know much about circuitry, but I am pretty sure that some that should stay relatively cool and quite, SHOULDN'T be making any noise, nor getting very hot. You should replace it before you fry your laptop.

#3 User is offline   phkninja 

  • Advanced Member
  • PipPipPip
  • Group: Members
  • Posts: 466
  • Joined: 28-February 05

Posted 23 May 2007 - 01:28 PM

actually all power supplies heat up after time, including in the desktop PC. Laptop power supplies usually heat up if used for long periods (because they dont have any cooling or heat vents usually) and is a normal effect in most power supplies, like the batteries heating up during charging or the laptop heating up on your lapp when being used for longer periods). The other bit is that is is very unlikely a laptop power supply will "fry" the laptop when it over heating becasue they contain current limiting circuitry and fusing so the power supply will fail before the laptop will be damaged .

The noise is a differnt thing. This could be a normal thing (mains frequency is at the ;low end of hearing range) and laptop power supplies are usually switch-mode devices. The only true way to get an ancswer for this is to contact the supplier to ensure there is no know fault with the power supplies issued.

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users



All trademarks mentioned on this page are the property of their respective owners
Copyright © 2001 - 2011 msfn.org
Privacy Policy